You literally have to start with the basics and go through the motions and apply the proper manufacturer recommend procedures to the diagnostic process to get the correct diagnosis. It’s never just easy as “hey, I think the lightbulb is bad, I need to swap it out for a new one!”🤔 So you hit the store buy a new bulb and you replace it and it…..and poof💨 it works now! (Maybe it does for a second…..but then it’s not working ten minutes later once again, 😬or the next day even!😱 So your out doing the same thing again, new bulb from the store , install it and hope it works this time…..😨 Nope, its not just we’re gonna go with whatever we assume it is….. no light output, now we gotta begin check list: Diagnostic: Fuses , relays, wiring, housing…. Then you get the solution. The wiring for the light housing was actually exposed, corroded and about to break apart entirely, causing the bulb to sporadically burn out. Needing a new wiring harness to be installed from the housing to the fuse box. Real solutions for this work isn’t something we can pull out of our neck on a whim……. We have to learn the right way to do things or it’s just a loss for everything and everyone involved! The right way that saves you time and money in the long run is taking the time to do the work