IF YOU WANT TO TRY TO MAKE A BAR OF SOAP SEND ME A MESSAGE. I made a MOLD for printing DANNI-DUCK shaped bars of soap. If you are crafty enough you could also pour melted candle wax into the mold and make and sell a candle. You have to print it SLOW but it works. This is the VERY FIRST mold I have ever made, so take that with a grain of salt. Print it and see if you can make it work.

Before I get do my 3rd tester I wanted to ask if anyone has any more recommendations for getting the beak to be smoother? I’m going to turn on ironing anything else? Also any help on getting the supports to break cleanly? Since my layer height is .16 I have my I think it’s call the Z height as .32. I also wanted ask how and where we are allowed to promote the ducks. I was going to promote on my page and in my black cheer moms group if that’s ok

I just sent you premium members TWO DUCK FILES. Please check your inbox.

@Darryl Cross Is there any way you can do Danni with a separate bow? I think it would print much faster and easier to remove supports. Also do we have access to the Danni with the uniform?

Printed my first Danni duck today. It mostly went well, had one support fail on the back of the hair. It didn't end up too bad, I had supports from bed only because I didn't want to leave marks on the back. The big problem I had was getting the supports out from behind the ponytail. Does it really need supports there? And if not how do I keep it form putting them there? I finally got them out but it left marks of pink back there. Sorry for so many questions but I'm relatively new to 3D printing.